AEG FAVORIT 2807 - Manual (Page 33)

33
Adjusting the worktop
You can move the worktop forward or
backward by 25 mm in order to align the
machine with other kitchen units.
Simply unscrew the two rear retaining
screws, move the top to the required
position and then retighten the screws.
Fitting under a counter (kitchen worktop or sink)
By removing the machine’s worktop, you can install it under a close fitting
sink unit or a pre-existing top, providing the dimensions of the recess
correspond to those shown in the picture.
Proceed as follows:
- Remove the machine’s worktop by
unscrewing the two rear retaining
screws, pull from the front and slide
out the rear slots, lifting the worktop.
- Insert the machine after adjusting
height and levelling with the adjustable
feet. When inserting the machine,
ensure that the water inlet and drain
hoses are not kinked or squashed.
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on the
levelling spacers on either side of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable feet
until the machine is perfectly level.
Installation
820
570 - 600
600
IN05
IN26
152982 05/1 en 14-04-2000 11:01 Pagina 33