AEG FAVORIT 2807 - Manual (Page 10)

10
Before using your dishwasher for the first time
1. Ensure that the electrical and water connections comply with the
installation instructions.
2. Remove all packaging from inside the appliance.
3. Set the water softener.
4. Pour 1 litre of water inside the salt container and then fill with salt.
5. Fill the rinse-aid dispenser.
Setting the water hardness range
The dishwasher is equipped with a water softener designed to remove
minerals and salts from the water supply, which would have a detrimental or
adverse effect on the operation of the appliance.
The higher the content of these salts, the harder your water is.
Water hardness is measured in equivalent scales, German and French.
The softener should be adjusted according to the hardness of the water in
your area.
To ensure optimum regeneration of the water softener:
- the water softenening must be set to the local water hardness;
- the dishwasher salt container must always be filled with special salt.
Your local Water Authority can advise you on the hardness of the water in
your area.
The dishwasher is factory set at level 2.
If this level is not suitable for your area the softener should be adjusted.
Water hardness
°dH
(german degrees)
°TH
(french degrees)
Use
of salt
Level
0
1
2
3
4
5
0 - 4
5 - 11
12 - 22
23 - 34
35 - 45
46 - 50
0 - 8
9 - 20
21 - 40
41 - 60
61 - 80
81 - 90
PPM
(parts per million)
0 - 80
81 - 200
201 - 400
401 - 600
601 - 800
801 - 900
NO
YES
YES
YES
YES
YES
152982 05/1 en 14-04-2000 11:00 Pagina 10