Teka HPE 635 - Manual (Page 15)

29
E
N
G
L
IS
H
28
INCIDENTS WHEN OPERATING THE PYROLYTIC FUNCTION
INCIDENT CAUSE SOLUTION
My accessories and shelf
suppor ts are damaged.
You have not removed the
accessories and supports during
the pyrolytic cleaning cycle.
You must replace them and
remove them in later cleaning
cycles.
The enamel colour has
changed and stains have
appeared.
The chemical composition of
some foodstuf fs may cause
changes in the enamel.
This is normal and does not
damage the proper ties of the
enamel.
The oven door is locked, pilot
light is lit up but the oven
is not hot.
You have turned the control
dial to position and no
other additional operation has
been per formed.
Switch off the oven and follow
the instructions to unlock the
door in the first 30 minutes at
a low temperature.
Next, select the pyrolytic
function, carefully following the
instructions.
I have turned the control dial
to position , pressed the
PIRO key, I can see the P1,
P2 or P3 on the display but
the pilot light is not lit up
and the oven is not heating
up.
The oven door is not closed
properly, so the door cannot
be locked.
Check the door and make
sure that it is closed properly.
I have turned the control dial
to position , pressed the
PIRO key, I can see the P1,
P2 or P3 on the display but
the pilot light is not lit up
and the oven is not heating
up.
The door switch is not working
even though the door is
properly closed.
Call Technical Assistance
Ser vice as there is a fault in
the door switch.
I have programmed the
pyrolysis function, the oven is
working properly but pilot light
is not lit up.
Pilot light does not work
properly.
Call the Technical Assistance
Ser vice.
The pyrolysis programme has
ended and the oven is cold,
but the door is locked and
symbol is flashing.
You did not turn the control
dial to position when the
pyrolysis programme ended.
1. Turn the control dial to
position and wait for 1
minute.
2. Turn the control dial to
position and wait for 1
minute.
3. Turn the control dial to
position again and wait
until pilot light turns of f.
4. Press the PIRO key for 3
seconds.
INCIDENT CAUSE SOLUTION
The control dial is in position
and the door is still locked.
The oven has not cooled down
to the safe temperature.
Wait until the temperature
lowers and pilot light turns
of f. Then, cancel the pyrolysis
programme.
The control dial is in position
, the oven is cold and the
door is still locked.
You have not followed the
instructions to cancel the
operation correctly.
1. Turn the control dial to
position and wait for 1
minute.
2. Turn the control dial to
position and wait for 1
minute.
3. Turn the control dial to
position again and wait
until pilot light turns of f.
I have put the control dial in
position and the door is
unlocked, however symbol
is still lit up and the
remaining time of the cleaning
cycle can be seen on the
display.
You have not followed the
instructions to cancel the
operation correctly.
Follow the instructions to
cancel the pyrolysis
programme.