beautypg.com

Driveline attachment, Driveline attachment -6, Assembly – Alamo A72 User Manual

Page 84: Assembl y

background image

ASSEMBLY

A60/A72 01/08

Assembly Section 3-6

©2008 Alamo Group Inc.

ASSEMBL

Y

Driveline Attachment

Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft (1). To
ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a
shield. Entanglement in rotating shafts can kill.
.

1. Attach the slip clutch end of the driveline to the

gearbox input shaft securely. (Figure Asm-
0090) Make certain that the slip clutch is fully
onto the input shaft splines. Tighten the
locknuts (2) alternately until they have reached
the proper torque. Refer to Torque Chart in the
Maintenance Section.

SLIP CLUTCH SHIELD ASSEMBLY

To attach the Slip Clutch Shield, follow the
procedures listed below (Figure Asm-R-0091).

1. Guide shield bracket (2) through weldment

shield (1) so that bracket stud screw potrudes
through weldment hole and retain in place with
wingnut (3).

2. Align holes of shield bracket with gearbox holes

positioned around input shaft. Retain bracket to
gearbox with three 3/8” x 3/4” bolts (6), 3/8”
washers (4), and 3/8” lockwashers (5).
Position hardware as follows: gearbox,
bracket, flatwasher, lockwasher, bolt. Tighten
bolts to recommended torque.

This manual is related to the following products: