Staub Electronics KIT-IR-RPTR-2X6 EPISODE - ELECTRONICS 2X6 IR REPEATER WITH POWER SUPPLY - Manual (Page 4)

4
LONG CABLE RUNS
When using long lengths of cable (>50 ft.), it may be necessary to
connect a 470 Ohm 1/8 Watt resistor between IR IN (signal) and
GND. The resistor discharges the cable capacitance, which allows
high bit-rate IR codes to work with higher reliability.
2.2.1. IR2X6 IR RECEIVER INPUT CONFIGURATION
7KH,5;FDQEHFRQ¿JXUHGWRVHQG,5IURPLQSXW%WRHPLWWHU
outputs 5 and 6 by setting the switches located next to the Emitter
outputs
2.3. TROUBLESHOOTING
When multiple IR Receivers are used in a system, the potential
for increased IR noise exists. This may affect the reliability of the
system and reduce the range of the IR. If this occurs, remove the
IR Receivers one at a time to determine the maximum number for
the installation.
SI
G
N
A
L
+1
2V
G
ND
GND
12V DC
IR Si
Jnal
IR Connectin
J Block
Terminals
470 Ohm 1/8 Watt
Resistor
6
A+B B
SW5 SW6
A+B B