Speaker connections, Speaker connections ……………………………………24, Ch at pe r 2 - c on ne ct io ns – Adcom GFR-700HD User Manual

Page 24: Gfr-700hd owner’s manual

r 2 - C

GFR-700HD Owner’s Manual

Speaker Connections

Follow these steps to connect your front (LF/RF),

center (C), and surround (LS/RS) speakers. For sub-

woofer or surround back connections, see page 25.

Connecting Speakers

1 Route speaker wire from your speakers to the

following GFR-700HD terminals:

• LF - Left front

• C - Center

• RF - Right front

• LS - Left surround

• RS - Right surround

2 Connect the speaker wires to the terminals using

one of the following connections:

• Bare wire - Tightly wind the exposed wire

strands and insert through the hole in the

binding post; then tighten the binding post

head in a clockwise direction.

• “U”-type spade connectors - Attach the

spade connector to the binding post and

hand tighten.

• “Banana” plugs - Insert the plug directly

into the binding post.

3 To ensure your speakers are in phase, make sure

your connections maintain proper polarity (posi-

tive to positive and negative to negative).

• The positive posts are red and labeled “+”.

• The negative posts are black and labeled “-”.

��

��

��

��

�

��

��
��
��

��

��

��

��

��

��

��

��

��

��

�

��

��

��

��

�

��

�

��

�

��

��

��

��

��

��

�

��

��

Notes:

• For subwoofer and surround

back connections, see page 25.

• 12~16 gauge speaker wire is

recommended.

• To conﬁgure the number, size,

crossover frequency, delay,

and balance settings for your
speakers, see pages 36-38.

Right

Surround

Right

Front

Left

Front

Left

Surround

Center

Bare wire

connection

“Banana” plug

connection

“U”-type spade

connection