Luxor|H.Wilson WGB4836 User Manual
Horizontal orientation vertical orientation

12/17/13
Wall-mounted Glass Board
Instructions
WARNING: Two people are required to
build this Glass Board. Use care when
handling the Glass Board.
Snap two horizontal chalk
lines at the shown height.
Drill four holes as shown
(Stud is recommended). If
there is no stud Hammer
drywall anchors B into holes.
Secure Pucks A at the
bottom like shown with
screw C make sure the
positioning is level and the
notch is facing up, leave
the clamp facing down.
Secure Pucks A at the top
with screw C make sure
the positioning is level and
the notch is facing down,
Secure the clamp with
wrench E so the clamp is
locked, facing up.
Semi-tighten the Puck clamps
A in the up position and place
the silicone inserts D into the
notches. Carefully lift the glass
board so that it rests on top of
the inserts, seated fully into the
notches, then tighten the clamps.
Wedge the silicone inserts
D into the open notch A.
Carefully push the glass
board into the open notch
and fold the silicone over the
glass and tighten the clamps
fully. Assembly Complete!
1
2
3
4
5
Parts List
- Tape Measure
- Chalk Line
- Drill
- 1/4˝ Drill Bit (No Stud)
- 1/8˝ Drill Bit (Stud)
- Extended Drive Phillips
- Hammer
- Level
- Stud Finder
- Pencil
A x4
B x4
C x4
D x4
E x4
Tools Required
Note: Hardware provided is for drywall installation. If attaching
to other material fasteners are to be furnished by other.
Chalk Line desired
bottom position.
Recommended
37
1
⁄
4
˝ from floor.
Chalk Line
35
7
⁄
16
˝ above the
bottom Chalk
Line
Chalk Line desired
bottom position.
Recommended
31
3
⁄
8
˝ from floor.
Chalk Line
47
7
⁄
16
˝ above the
bottom Chalk
Line
6
13
⁄
16
˝
4
13
⁄
16
˝
4
13
⁄
16
˝
4
13
⁄
16
˝
4
13
⁄
16
˝
6
13
⁄
16
˝
6
13
⁄
16
˝
6
13
⁄
16
˝
26˝
26˝
35˝
35˝
Hole Locations
Hole Locations
35
5
⁄
8
˝ x 48
5
⁄
8
˝ Board
48
5
⁄
8
˝
48
5
⁄
8
˝
36
5
⁄
8
˝
36
5
⁄
8
˝
Hole Locations
Hole Locations
Horizontal Orientation
Vertical Orientation
STUD
NO STUD
DRYWALL
RECOMMENDED:
1/8˝ Bit
1/4˝ Bit
DRYWALL
Assembly
Requires Two
People
Perform the
steps detailed in
unison, having a
person on each
side tighten
adjacent pucks
at the same time.
B
A
A
C
C
E
1.
3.
2.
4.
E
E
A
A
A
A
D
D
D