Luxor|H.Wilson WGB4030 User Manual
Horizontal orientation vertical orientation
12/17/13
Wall-mounted Glass Board
Instructions
WARNING: Two people are required to
build this Glass Board. Use care when
handling the Glass Board.
Secure Pucks A at the
bottom like shown with
screw C make sure the
positioning is level and the
notch is facing up, leave
the clamp facing down.
Secure Pucks A at the top
with screw C make sure
the positioning is level and
the notch is facing down,
Secure the clamp with
wrench E so the clamp is
locked, facing up.
Semi-tighten the Puck clamps
A in the up position and place
the silicone inserts D into the
notches. Carefully lift the glass
board so that it rests on top of
the inserts, seated fully into the
notches, then tighten the clamps.
Wedge the silicone inserts
D into the open notch A.
Carefully push the glass
board into the open notch
and fold the silicone over the
glass and tighten the clamps
fully. Assembly Complete!
1
2
3
4
5
Parts List
- Tape Measure
- Chalk Line
- Drill
- 1/4˝ Drill Bit (No Stud)
- 1/8˝ Drill Bit (Stud)
- Extended Drive Phillips
- Hammer
- Level
- Stud Finder
- Pencil
A x4
B x4
C x4
D x4
E x4
Tools Required
Note: Hardware provided is for drywall installation. If attaching
to other material fasteners are to be furnished by other.
Chalk Line desired
bottom position.
Recommended
37
1
⁄
4
˝ from floor.
Chalk Line
29
13
⁄
16
˝ above the
bottom Chalk
Line
Chalk Line desired
bottom position.
Recommended
31
3
⁄
8
˝ from floor.
Chalk Line
39
13
⁄
16
˝ above the
bottom Chalk
Line
30˝
40˝
3˝
3˝
3˝
3˝
4˝
4˝
4˝
4˝
24˝
24˝
32˝
32˝
Hole Locations
Hole Locations
30˝ x 40˝ Board
40˝
30˝
Hole Locations
Hole Locations
Horizontal Orientation
Vertical Orientation
STUD
NO STUD
DRYWALL
RECOMMENDED:
1/8˝ Bit
1/4˝ Bit
DRYWALL
Assembly
Requires Two
People
Perform the
steps detailed in
unison, having a
person on each
side tighten
adjacent pucks
at the same time.
B
A
A
C
C
E
1.
3.
2.
4.
E
E
A
A
A
A
D
D
D
Snap two horizontal chalk
lines at the shown height.
Drill four holes as shown
(Stud is recommended). If
there is no stud Hammer
drywall anchors B into holes.