Luxor|H.Wilson OHT50 - Manual

Instruction Sheet
OHT50 Overhead Projector Cart
Customer Service Dept
2245 Delany Rd
Waukegan, IL 60087
Ph: 847/244-1800 • 800/323-4656
Fax: 847/244-1818 • 800/327-1698
With bottom shelf facing up push all four 17 1/2˝
legs onto leg posts. Using rubber mallet hammer
legs firmly into position. Legs must be seated
(flush) against the shelf surface.
17 1 ⁄ 2 ˝ LEG
LEG POST
BOTTOM
SHELF
Gently tap corner post into leg. Repeat on all
4 sides until all posts are partially inserted
into legs. Now repeat hammering action more
firmly going around to each shelf post and
driving the leg posts more securely into the
legs.
CENTER SHELF
Lay two halves of top shelf, ribbed side up, on a
smooth surface. Join both halves using 2 sheet
metal screws into predrilled shelf holes as shown,
and secure. There are 2 plug housings. Close up
one using electrical housing cover and 2 screws.
TOP SHELF (2 PCS)
ELECTRICAL
HOUSING
COVER
ELECTRICAL
ASSEMBLY
Push power cord into other plug housing. Secure
power cord with “L” bracket and 2 screws.
3 PLUG UNIT
“L”
BRACKET
PLUG HOUSING
POWER CORD
Push remaining 4 legs onto shelf posts as illustrat-
ed. Slide cord wrap over leg as shown. Place top
shelf onto legs. Insert posts into legs of top shelf.
Using rubber mallet, firmly hammer top shelf unto
legs until all 4 legs are seated against shelf sur-
faces. Remove rubberband.
6˝ LEGS
CENTER
SHELF
CORD
WRAP
TOP
SHELF
Push the four casters firmly into the holes in
each corner of the bottom shelf. Important:
casters must be fully seated. Tap firmly with
rubber mallet to properly seat casters. Turn
your table right side up.
PLACE LOCKING CASTERS AS
ILLUSTRATED