Luxor|H.Wilson LE27CWTUD - Manual (Page 6)

LEWTUD & LEWCTUD Series
®
6
LEWTUD & LEWCTUD Assembly Instructions
Caster Wheels Rubber Mallet Bottom Shelf
Rubber Mallet
Long Legs
Bottom Shelf
Step 1. Push the four casters firmly into the holes in each
corner of the bottom shelf.
Important: Casters must be fully seated. Tap firmly with
rubber mallet to properly seat casters.
Step 2. Insert the 4 long legs into each corner. Using the
rubber mallet, firmly tap each leg unit it is seated securely into
position.
NOTE:
If you have a cabinet pack, go to page 15 and follow the
cabinet pack instructions.
NOTE:
If you have a 2 shelf unit continue to step 5.
Step 3. Position the center shelf over the long legs and insert
each mounting post into each leg. Using a rubber mallet, firmly
hammer center shelf into legs until all four legs are seated (flush)
against the surfaces of both shelves.
Step 5. Before installing the top shelf, slide the power cord storage
arm over the short leg on the handle side. The power cord storage arm
will allow the user to easily store the power cord while allowing easy
extraction when the cord is needed.
Step 4. Push remaining 4 short legs onto leg posts of center
shelf. Tap firmly into place using the rubber mallet.
Rubber Mallet
Center Shelf
Short Legs
Rubber Mallet
Power Cord Storage Arm
Note: Not included in all
models.