LockeyUSA 2500 Hookbolt - Manual (Page 2)

Step 8: Using the Lockey 2200/2500
From Outside:
The door will LOCK by turning the knob to extend the
deadbolt/hookbolt.
To UNLOCK, press the “C” button to clear the lock, enter the
combination and turn the knob to retract the deadbolt/hookbolt.
NOTE: IF DEADBOLT/HOOKBOLT RETRACTS WITHOUT COMBINATION
AND REQUIRES COMBINATION TO LOCK (EXTEND), YOU MAY NEED TO
CHANGE HANDING. SEE STEP 3.
From Inside:
The door will LOCK and UNLOCK by turning the knob to extend or
retract the deadbolt/hookbolt.
Step 7: For Doors Under 1” Thick (if necessary)
1. For doors under 1” thick, you will need to cut the spindle to
appropriate size. See Step 5 to verify correct Spindle Length.
2. Remove Hex Bolts and use M5 Screws supplied in Thin Door Kit
(TDK) packet to secure lock to door.
6. Replace the cover plate and secure with four (4) Red Screws,
using a #2 screwdriver.
7. TEST CODE before installing/re-installing lock.
4. While holding the ‘C’ BUTTON, remove/add CODE (Red) and NON-CODE
(Blue) Tumblers to create your desired code.
Ex: 3 Red = 3-Digit Code / 6 Red = 6-Digit Code
IMPORTANT: Ensure notched side of tumbler fits into slot. (Below – Far Right).
5. After changing your code, release the ‘C’ BUTTON to secure the tumblers
in place.
3. PRESS & HOLD ‘C’ BUTTON to release tumblers.
IMPORTANT: ‘C’ Button must be pressed and held down when removing
and inserting tumblers. Failure to do so will damage the lock and void
the warranty.
Lockey 2000 Series
How to Change Code
1. Using a #2 screwdriver, remove the four (4) Red Screws.
2. Carefully remove cover plate.
WARNING: Springs are attached to plate.
RED = CODE TUMBLERS
BLUE = NON-CODE TUMBLERS
‘C’ = CLEAR (DO NOT REMOVE)
WARNING:
Do NOT force tumblers into position!