LevelOne VOI-7100 - Manual (Page 13)

8
2.4. Installation
1. Connect IP Phone RJ45 WAN port to NAT Router using a Category 5
LAN cable.
2. Connect IP Phone RJ45 LAN port to Notebook PC using a Category 5
LAN cable.
3. Connect DC power adaptor, and the LCD panel will start showing Loading
Program! and System Initialized.
4. The LCD panel will show Date, Time and No service without SIP
registration, or after successful SIP registration.
5. Pick up the phone, and the LCD panel will show IP Dialling.., and you
should hear a dial tone. Please hang up. If not, please check if the RJ45
WAN port is connected.
6. Press MENU / 4.Network / 2.Status from the keypad to check the IP
address for IP Phone. The MENU key is used for escape, and the ENTER
key for selection. The default IP address is 192.168.1.100. You need this
IP address for Web configurations in Chapter 7.
7. Please refer to VoIP applications examples of SIP registrations, and
register IP Phone into your SIP server.
8. The LCD panel will show Date, Time and registered
after successful SIP registration.
9. Press the Hand-Free key, and you should hear a dial tone. Press
123456# to call the party with the number 123456 registered in the SIP
server. Note that # will dial out the number immediately. Dialling without #
will not dial out until the auto dial timer (default=5 seconds) elapsed. In a
moment, you should hear a ring back tone, and wait for answer.