LevelOne WAP-6101 - Manual (Page 56)

installation steps listed below are applicable for all network adapters.
1. Go to Start > Right click on “My Computer” > Properties.
2. Select the Hardware Tab.
3. Click Device Manager.
4. Double-
click on “Network Adapters”.
5. Right-click on Wireless Card bus Adapter or your specific network adapter.
6. Select Properties to ensure that all drivers are installed properly.
7. Look under Device Status to see if the device is working properly.
8. Click “OK”.
2 What can I do if my Ethernet connection does not work
properly?
A. Make sure the RJ45 cable connects with the device.
B.
Ensure that the setting on your Network Interface Card adapter is “Enabled”.
C. If settings are correct, ensure that you are not using a crossover Ethernet cable,
not all Network Interface Cards are MDI/MDIX compatible, and use a patch cable
is recommended.
D.
If the connection still doesn’t work properly, then you can reset it to default.
3 Something wrong with the wireless connection?
A. Can‟t setup a wireless connection?
I. Ensure that the SSID and the encryption settings are exactly the same to the
Clients.
II. Move the WiFi Concurrent 300Mbps Business AP and the wireless client
into the same room, and then test the wireless connection.
III. Disable all security settings such as WEP, and MAC Address Control.