LevelOne WAP-3000 - Manual (Page 8)

Hardware connections
Connecting with power adapter
1. Plug in network cable to the Ethernet port of the Switch/Hub, and plug in the other end to the
Ethernet port of the Wireless Access Point.
2. Plug in DC plug of the power adapter to the DC jack of the Wireless Access Point, and plug in the
power adapter to the power outlet.
Connecting with PoE switch (WAP-3100 only)
1. Plug in network cable to the Ethernet port of the PoE Switch, and plug in the other end to the
Ethernet port of the Wireless Access Point.
Check the installation
The LEDs of the Access Point are clearly visible and the status of the network link can be seen
instantly:
1. With the power source on, once the device is connected, the Power, LAN and WLAN port LEDs
will light up indicating a normal status.
2. If the LAN Port’s Link indicator does not light up then check the RJ-45 cable if it is firmly feed to
the RJ-45 port, while the LAN is link up to the Switch/Hub, the LAN port’s LED will light up.
5