LA STEELCRAFT FB1-552-HS - Manual (Page 5)

5'-0" (TO FRONT OF CROSSBAR)
FINISHED GRADE
END VIEW
10'-0" ABOVE
5'-0" radius
DATE: 7/17/12 DO NOT SCALE DRAWING
STEELCRAFT PRODUCTS
P.O. Box 90365 - Pasadena, CA 91109
PHN 626-798-7401 FAX 626-798-1482
MODEL
5 of 5
SHEET
FB1-552
FOOTBALL GOAL
DRAWN BY: AFS
NOTE: SPECIFICATIONS ARE SUBJECT TO CHANGE
ASSEMBLY INSTRUCTIONS:
1. DIG A FOOTING HOLE AT 5’-0” BEHIND THE END ZONE LINE IN
THE CENTER OF THE FIELD AT 30” DIA. AND 7’-6” DEEP.
2. PLACE SLEEVE INTO FOOTING HOLE AND POSITION THE TOP OF
THE SLEEVE AT 6” BELOW FINISHED GRADE. PLUMB THE SLEEVE
AS BEST AS YOU CAN AND SET THE ALIGNMENT BOLTS IN LINE
WITH THE FIELD. POUR CONCRETE INTO THE HOLE UP TO
APPROXIMATELY 12” BELOW FINISHED GRADE. (BELOW THE
POSITIONING BOLTS.) ALLOW THE CONCRETE TO SET FOR A
MINIMUM OF 48 hrs. BEFORE PROCEEDING TO THE NEXT STEP.
3. PLACE THE “GOOSENECK” POST INTO THE SLEEVE USING A
LIFTING DEVICE OF SOME KIND. ROTATE THE POST SO THAT IT IS
SQUARE TO THE GOAL LINE. USING THE BOLTS ON THE SIDE OF
THE SLEEVE, PLUMB THE POST IN A VERTICAL POSITION.
4. INSERT THE CROSS BAR INTO THE END OF THE POST. INSERT THE
BOLT AND TIGHTEN THE SET SCREWS SO THE CROSS BAR IS LEVEL.
5. INSERT THE UPRIGHT ASSEMBLY IN THE END OF THE CROSS BAR
AND POSITION THE UPRIGHT STUBS IN A PLUMB POSITION.
TIGHTEN THE SET SCREWS. REPEAT THIS FOR THE OTHER END OF
THE CROSS BAR.
6. INSERT THE UPRIGHT POSTS ON THE STUBS AND TIGHTEN THE SET
SCREWS.