LA STEELCRAFT 810JH4S - Manual (Page 2)

10'-2 1/2"
20'-6"
10'-2 1/2"
3'
810JH-4S
PORTABLE
BASEBALL BACKSTOP
8'-6"
PLAN VIEW
FRONT VIEW
NOTE: SPECIFICATIONS ARE SUBJECT TO CHANGE
PHN 626-798-7401 FAX 626-798-1482
DATE: 10/5/09 DRAWN BY: AFS DO NOT SCALE DRAWING
STEELCRAFT PRODUCTS
P.O. Box 90365 - Pasadena, CA 91109
MODEL
ASSEMBLY INSTRUCTIONS
1. Assemble the two skids (E) on the ground to form a right angle. Slide the 3 way
fittings (G)on each skid pipe. Note that there are right and left hand units.
2. Attach the three elbow fittings (F) to each end of the skid pipe.
3. Insert the cross brace pipe (D) into the 3 way fittings between the skids.
4. Assemble the four uprights (A) into the fittings and attach the two pre-fab corner
sections (Z) and secure with the set screws.
5. Attach the front rail (D) into the pre-fab sections and secure with set screws.
6. Attach the three horizontal pipe braces (B) with the rail end fittings (H) and brace
bands (I).
7. Straighten framework and securely tighten all set screws using a hammer and
socket key.
8. Attach the 11 ga. fabric to the center hood section. Weave the two tension bars
(M) into last loop on each side of the fabric and attach to the pre-fab frames with
tension bands (K). Use six on each side. Stretch fabric tight.
9. Measure the distance on the vertical panels so you can cut the 9 ga. fabric to the
proper length. Unweave one strand of wire and then insert a tension bar (L) into the
last loop of each end. Place the panel between two posts with the tension bars
adjacent to the post and attach in the same manner as the hood section using
tension bands (J). Stretch fabric tight.
10. Assemble the remaining two panels in the same manner. Using the tie wire (N),
fasten fabric to the horizontal braces (B), skids (E), pre-fab corners (Z) and bottom
brace (D).