AEG LAVATHERM 59800 - Manual (Page 25)

25
Programming options
Objective Implementation
Permanently programme
in the audible signal
which reminds you that
the programme is com-
plete.
1. Turn the programme selector to any programme.
2. Press the SIGNAL (ZOEMER) button and hold down for
approx. 5 seconds.
A brief signal sounds several times. The SIGNAL (ZOEM-
ER) display flashes several times.
The setting is permanently programmed.
The setting is cancelled as described under 1 and 2.
Adjust “level of dryness”
detection:
If the laundry is slightly
drier or slightly damper
at the end of the pro-
gramme than with the
standard setting.
1. Turn the programme selector to any programme.
2. Press the SILK (ZIJDE) and SIGNAL (ZOEMER) buttons at
the same time and hold down for approx. 5 seconds.
The current setting appears on the multi-display:
– C0: Setting for drier laundry
– C1: Standard setting
– C2: Setting for damper laundry
3. Press the START/PAUSE (START/PAUZE) button until the
setting required appears on the multi-display.
4. Turn the programme selector to OFF (UIT).
The setting is permanently programmed.
To deactivate the EMPTY
WATER (RESERVOIR) dis-
play when using an ex-
ternal drain for the
condensed water.
1. Turn the programme selector to any programme.
2. Press the WOOL (WOL) and LONG ANTICREASE (ANTI-
KREUK) buttons at the same time and hold down for ap-
prox. 5 seconds. The multi-display briefly displays ”0”
The EMPTY WATER (RESERVOIR) display is permanently
deactivated.
The setting is cancelled as described under 1 and 2; the
multi-display however briefly displays ”1” (rather than
”0”).