AEG LAVATHERM 59800 - Manual (Page 16)

16
Putting in extra items or taking items out before end of
programme
1. Open loading door
1
Warning! Laundry and drum can become hot. Risk of burns!
2. Load or remove laundry items.
3. Close loading securely. Lock must audibly lock.
4. Press the START/PAUSE (START/PAUZE) button to continue the drying
cycle.
Drying cycle complete / removing laundry
Once the drying cycle is complete, the END (EINDE) and CREASE GUARD
(ANTI-KREUK) indicators light up. If the SIGNAL (ZOEMER) button has
been pressed, an acoustic signal sounds intermittently.
3
The drying cycles (except for the WOOL (WOL) programme) are auto-
matically followed by an anti-crease phase which lasts around 30 min-
utes. The drum rotates at intervals during this phase. This keeps the
laundry loose and free of creases. The laundry can be removed at any
time during the anti-crease phase. (The laundry should be taken out to-
wards the end of the anti-crease phase at the latest to prevent creases
from forming.) If LONG ANTICREASE (ANTI-KREUK) has been selected,
the anti-crease phase is lengthened by 60 minutes.
1. Open door.
2. Before removing the laundry, remove fluff from the micro-fine filter. It
is best to use a damp hand for this purpose. (See “Cleaning and mainte-
nance” section.)
3. Remove laundry.
4. Turn the programme selector to OFF (UIT).
Important: After each drying cycle
– Clean the micro-fine filter and fine filter
– Drain the condensed water container
(See section “Cleaning and maintenance”.)
5. Close door.