beautypg.com

Changing the bulb for interior lighting – AEG LAVATHERM 59800 User Manual

Page 24

background image

24

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The spe-
cial bulb can be obtained from the Customer Care Department, ET no.
112 552 000-5.

3

Important: When the appliance is switched on, the interior lighting
switches itself off after 5 minutes when the door is open.

1

Warning: Do not use standard bulbs! These develop too much heat and
may damage the appliance.

1

Warning: Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.

1. Unscrew cover above the bulb (this can be found directly behind the

loading aperture, at the top; refer to “Description of machine” section.)

2. Replace defective bulb.
3. Screw cover back down.

1

Warning: For safety reasons, the cover must be screwed down tightly.
If this is not done, the dryer must not be operated.

Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle com-
plete“).

Lint filter clogged.

Clean lint filter.

Fluff filter clogged.

Clean fluff filter.

Load volume too big.

Reduce load volume.

Laundry insufficiently spun.

Laundry must be adequately
spun.

Particularly high room tem-
perature. Temporary switch-
ing off of the compressor to
avoid overload.

Automatic process, there is no
fault with the appliance. If
possible, lower the room tem-
perature.

Problem

Possible cause

Remedy