Harrington Hoists and Cranes HPC 500 End Truck - Manual (Page 23)

23
Table 5-2 Inspections Methods and Criteria
Component Item Method Criteria Corrective Action
Runway
Fasteners
Check tightness
Measure torque
Fasteners must be sufficiently tight.
Refer to torque values listed in
Section 3.
Tighten
Wheel Running
Surfaces
Visual
The surfaces on which the end
truck wheels run must be free of oil,
grease or paint.
Clean/remove
contaminants
Wheel Running
Surfaces
Visual
The surfaces on which the end
truck wheels run must not be worn
excessively.
Replace.
Dimensions Measure
The span, straightness, elevation
must be within allowed tolerances
as specified by CMAA Spec. 74.
Adjust/repair
Bridge
Beam
Bridge Beam
Visual
Measure The beam must not be deformed or
damaged.
Repair or replace
Welded parts
Visual
NDT
Welds to be in accordance with
weld specifications of CMAA Spec.
74.
Repair
Lower Flange Visual
The travel surface must not be
worn excessively.
Replace
Fasteners
Check tightness
Measure torque
Fasteners must be sufficiently tight.
Refer to torque values listed in
Section 3.
Tighten
Deflection Measure
Deflection at mid-span under rated
load must be less than 1/600 of the
span.
Repair , replace, or
down-rate
Capacity
Label(s)
Visual
Label(s) must be legible and
securely attached.
Repair or replace
End Truck
Wheel Tread Measure
Wheel diameter must not be less
than the “Min. Value for
Replacement” listed in Table 5-3.
Replace
Wheel Flange Visual
Wheel flange must not be worn
excessively.
Replace
Fasteners
Check tightness
Measure torque
Fasteners must be sufficiently tight.
Refer to torque values listed in
Section 3.
Tighten