Harrington Hoists and Cranes HPC 500 End Truck - Manual (Page 13)

13
7
2
2
BEAM FLANGE HOLES
(from Fig. 3-1)
SPAN
7
Figure 3-3 Bridge Beam Web Holes – T
OP R UNNING
3.2.5 End Stop Installation – This step covers the installation of the end stops onto the bridge beam.
 Locate the holes that were installed in the web of the bridge beam (step 3.2.4 above). These are
the holes for attaching the end stops to the bridge beam.
 Attach the four (4) end stops to the bridge beam in accordance with Figure 3-4. Fully tighten the
fasteners by applying 75 ft-lb of torque.
HEX-HEAD
CAP SCREW
END STOP
SPRING WASHER
HEX NUT
BRIDGE BEAM
BRIDGE BEAM
END STOP
Figure 3-4 End Stop Installation