Grant Part #4324 - Standard Installation Kit - Manual

INSTRUCTION SUPPLEMENT
READ BEFORE ASSEMBLING WHEEL
AFTER THE EXISTING STEERING WHEEL AND ASSOCIATED
HARDWARE HAVE BEEN REMOVED AS INDICATED IN YOUR
INSTRUCTION SHEET PLACE SLEEVE OVER STEERING
SHAFT AS SHOWN ABOVE.
IMPORTANT NOTE
SLEEVE SHOULD FIT FREELY OVER SHAFT AND SLIDE
DOWN UNTIL IT BOTTOMS.
ON SOME MODELS THE PLASTIC TURN SIGNAL CANCELING
MECHANISM PREVENTS THIS SLEEVE FROM BOTTOMING
OR FITS SNUGLY AGAINST THE SIDES OF SLEEVE. IF
EITHER OF THESE CONDITIONS EXIST, DO NOT USE
SLEEVE, IT IS NOT REQUIRED.
CONTINUE WITH INSTRUCTIONS FOUND WITH KIT AND
WHEEL.
97521-00-01