Alamo SR14 - Manual (Page 132)

MAINTENANCE
MAINTENANCE
SR20M/SR14M 04/94 Maintenance Section 5-2
© 2004 Alamo Group Inc.
Before operating your Rotary Cutter, make sure it is properly lubricated and thoroughly inspected. Only a
minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life
and trouble free operation.
WARNING Always disengage the PTO before raising the Rotary Cutter for transporting or making
adjustments.
LUBRICATION INFORMATION
Do not let excess grease collect on or around parts, particularly when operating in sandy areas. The
accompanying illustration shows lubrication points. The chart gives the frequency of lubrication in hours,
based on normal operating conditions. Severe or unusual conditions may require more frequent lubrica-
tion. FIGURE 1.
Use an SAE multi-purpose, lithium-type grease for all locations shown except location #2 use lubricant
NLGI 000 Grease (P/N 000769030). Be sure to clean the fitting thoroughly before using grease gun. Daily
lubrication of the wing driveline slip joint is necessary. Failure to maintain proper lubrication will result in
damage to U-joints, gearbox, and/or driveshaft.
Lubrication Fitting Location
ITEM DESCRIPTION FREQUENCY
1 U-Joints 8 hours
2 Gearbox Check daily
3 Divider Gearbox Check daily
4 Axle Adjustment Rod 8 Hours
5 Wheel Hubs Weekly
6 Axle Pivot Points 8 hours
FIGURE 1
6 6 6 5 5 5 5 6 4 4
3
1
1
1
1
2
2
2