Sonnet Technologies Fusion RX1600RAID (Without Drives) - Manual (Page 6)

Enclosure Setup
6
Install Drives Into Drive Trays (continued)
4. With the lever facing the left, slide a drive tray over the drive and
align its holes with the screw holes in the drive (Figure 11).
5. Using three of the supplied screws, secure the drive tray to the
drive; tighten each screw to secure the tray to the drive; do not
overtighten the screws (Figure 11).
6. Flip the drive and drive tray over so that they are resting on the
other side. While supporting them, push the drive tray rail up to
expose the screw holes on the side of the drive, and then apply a
single drop of threadlocker inside each of the three holes
(Figure 12).
7. Using three of the supplied screws, secure the drive tray to the
drive; tighten each screw to secure the tray to the drive; do not
overtighten the screws (Figure 12).
8. Repeat steps 3–7 for each remaining drive.
Prepare Fusion RX1600RAID Drive Enclosure for Use
1. With its lever fully opened, carefully slide the drive module into
any slot in the enclosure until it stops, and then secure it by
pushing the lever in until it snaps closed
(Figure 13).
2. Repeat step 1 for each remaining drive module.
Connect Fusion RX1600RAID Drive Enclosure to Sonnet
RAID Controller
This section describes the connection of the Fusion RX1600RAID
drive enclosure to the Sonnet RAID controller card.
1. Insert one end of each of the supplied data cables to the PRM
LINK mini-SAS ports on the enclosure; verify the connectors are
plugged in securely (Figure 14).
Figure 12
Figure 11
drive tray screw
drive
drive
drive tray rail
screw hole
screw hole
screw hole
WARNING: When inserting drive modules into the enclosure,
do not force the levers closed. If a lever does not close easily,
remove and reinsert the module, and then push the lever in again.
Figure 13
Push lever in
until it snaps
closed
Push tray in
until it stops
Figure 14
mini-SAS
connector