Sonnet Technologies Fusion RX1600RAID (Without Drives) - Manual (Page 5)

Enclosure Setup
Figure 7
2. Using four of the provided rack mounting screws, secure the
RX1600RAID enclosure to the rack; do not overtighten the
screws (Figure 7).
Install Drives Into Drive Trays
1. Pull a drive tray out of its packaging, and then using wire
cutters, cut off the shipping support between the drive tray rails
(Figure 8). Be sure to cut the plastic flush; do not leave a rough
cut (Figure 9).
2. Repeat step 1 with each remaining drive tray.
3. Remove a SATA drive from its packaging and set it on edge on
a flat, level surface with the label facing away from you and the
connectors to the right. Open the supplied tube of threadlocker
and apply a single drop inside each of the three screw holes on
the side of the drive
(Figure 10).
5
screw
Figure 8
Figure 9
Figure 10
screw hole screw hole screw hole
flush cut
GOOD!
rough cut
NO
GOOD!
shipping
support
WARNING: When handling computer products, take care to
prevent components from being damaged by static electricity;
avoid working in carpeted areas. Handle hard drives only by their
edges and avoid touching connector traces and component pins.
WARNING: If you do not cut off the edges of the shipping
support flush with the drive tray rails, the drive tray will not fit
properly in the enclosure, and the storage system may not work
reliably.