Assembly, Assembl y – Alamo 02979718C User Manual

Page 80

ASSEMBLY

UGR 04/06

Assembly Section 3-6

ASSEMBL

Then, while holding the handle to expose the plunger

rod, thread the threaded bead of the cable into the end

of the plunger rod and tighten securely. Release the

handle, allowing the cable to pull into the control stick

assembly.

Once cable is attached to plunger rod, slide the silver

conduit sleeve into the bottom of the control stick

assembly and align the groove in the conduit sleeve

with the cross screw hole.

Finally, reinstall the cross screw and tighten securely.