American International Electric SEG-M - Manual (Page 3)

Section 2: Product Overview
2.1 Product Specifications
The chart below contains the environmental and electrical specifications.
Electrical
Voltage 12VDC (9V Min; 20V Max)
Current 150mA @ 9V; 100mA @ 20V
Environmental
Temperature 0° to 70 ° C (32° to 158° F)
Humidity 0-95% RH Non-condensing
Environment Indoor Only
2.2 LED Status
The following diagram and chart describes the SEG LED operations.
Data Send/Recieve (Top Left) Network Link (Top Right)
Solid Idle
Flashing
Receiving data from
Hub Manager Pro and it is
being properly decrypted
Solid Good Network Link
Off No Network Link
Status (Bottom Left) Diagnostics (Bottom Right)
Solid (with top left blinking)
1x EEPROM Checksum Error
2x RAM Error
3x Network Controller Error
4x EEPROM Checksum Error
5x
Duplicate IP Address on
the Network
Flashing (with top left blinking)
4x Faulty Network
Connection
5x
No DHCP Response
Received
6x Software does not Match
Hardware
Flashing Alternately with
Bottom Left Module is in Setup Mode
Document Number: 6066005, Rev 3.2 Page 3 of 34