SKC 223-Series PowerFlex - Single User Manual
Powerflex, Battery charging system, Operating instructions

PowerFlex
Battery Charging System
Small and lightweight, the SKC PowerFlex
®
is an advanced charging system
designed for optimal charging of NiCad and NiMH batt ery packs for most SKC
personal air sampling pumps.
Pump-specifi c cables are used to connect batt ery packs to the PowerFlex so that
only one charger is needed for most SKC personal sample pumps (excluding Ex
and ATEX models and models with lithium-ion [Li-Ion] batt eries). PowerFlex
fully charges batt ery packs in 6 to 8.5 hours, and then automatically switches
to a safe pulse trickle charge. An LED indicates batt ery charge status. Batt ery
packs can be charged att ached to or detached from the pump.
Performance Profi le*
Dimensions:
1.2 x 2.3 x 4.6 in (3.0 x 5.8 x 11.7 cm)
Weight:
4 oz (0.1 kg)
Charging time
‡
:
6 to 8.5 hrs
Status LED:
Steady Red = Charging
Steady Green = Trickle charge
Input voltage:
223-2000: 100-240 V
Intrinsic safety:
Not intended for use in explosive or hazardous
locations
Approvals:
Power supply is
for electrical safety and
is CE marked.
* For U.S.-produced pump models only. Not compatible with Ex or ATEX-approved models.
‡ Typical charging times vary with model, batt ery capacity, and level of discharge.
Operating Instructions
863 Valley View Road, Eighty Four, PA 15330 USA
Tel: 724-941-9701 Fax: 724-941-1369 e-mail: [email protected]