SKC 222-2301 Grab Air Sample Pump - Manual (Page 4)

5
Properly Filled Bag Improperly Filled Bag
4. Sample until the bag is fi lled properly.
5. Slide the pump's On/Off switch to Off .
6. Disconnect the tubing by pulling it straight up and off the pump inlet, close
the bag inlet valve, identify the sample, and send to a laboratory for analysis.
The pump should be purged after bag sampling. To purge the pump, run
it for several minutes in a clean air environment. If the contaminant is
hazardous, take all necessary safety precautions.
To avoid breaking the pump inlet fi tting, pull tubing straight up and off
the pump inlet. Do not remove tubing from inlet at an angle.
Failure to follow warnings and cautions voids any warranty.