SilverStone NJ520 - Manual (Page 3)

NIGHTJAR SERIES
02
1.6 STANDBY MODE
During measurement of the ”STANDBY MODE” condition, the main converter
is off (PS_ON=High). +5Vsb converter is working and standby input power is
measured.
1.7 ACTIVE POWER FACTOR CORRECTION (PFC):
PFC at half/full load:
>0.95 at AC 110v 60Hz (typical)
>0.90 at AC 230v 50Hz (typical)
NOTE:
1.The continuous maximum total output power shall not exceed 520W.
+12V DC maximum output power shall not exceed 43A (516W).
+3.3V and +5V DC maximum combined output power shall not exceed 100W.
2.0 OUTPUT:
Load
Condition Efficiency Power
in
<45mA ---- <0.45W
45mA >=50% ----
100mA >=55%
250mA >=65% ----
1.0A >=75% ----
*2013 ErP Standby efficiency
GROUP
VOLTAGE +3.3V
20A
0A
±2%
50
10000
+5V
20A
0A
±2%
50
10000
+12V
43A
0A
±2%
120
10000
-12V
0.5A
0A
±10%
120
330
+5VSB
2.5A
0A
±4%
50
10000
MAX.LOAD
MIN.LOAD
REGULATION
RIPPLE & NOISE (mV)
Capacitive Loads_(uF)
1 2