SilverStone ST46GF Manual - Manual (Page 8)

4.3 Over Current Protection
The power supply should contain the OCP function on each hot swap module.
The power supply should be shut down in a latch off mode while the respective output current
exceeds the limit as shown in Table 8. When the latch has been cleared by toggling the PSON#
single or cycling the AC input power. The power supply module should not be damaged in this
condition.
4.4 Short Circuit Protection
The power supply shall shut down in a latch off mode when the output voltage is short circuit.
Table 7 –Over Voltage protection
Table 8 –Over Current protection
07
Voltage
+5V
+3.3V
+12V
5VSB
Minimum
+5.7V
+3.9V
+13.3V
+5.7V
Maximum
+6.5V
+4.5V
+14.5V
+6.5V
Shutdown Mode
Latch Off
Latch Off
Latch Off
Auto recovery
Voltage
+5V
+3.3V
+12V
Operating Temperature Range:
Non-Operating Temperature Range:
0°C ~ 40°C (32°F~ 104°F)
-40°C ~ 70°C (-40°F~ 158°F)
Minimum
110%
110%
110%
Maximum
160%
160%
160%
Shutdown Mode
Latch Off
Latch Off
Latch Off
5. Environmental Requirements
5.1 Temperature