beautypg.com

Assembly instructions – Rivers Edge RE722 5' EXT FOR DOUBLE RUNG CLIMBING AID User Manual

Page 9

background image

Check for parts online at

www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5

9

Operator's Manual

Rivers Edge Climbing Aids

ASSEMBLY INSTRUCTIONS

(RE708, RE709, RE710)

Tools needed – two 7/16" wrenches
IMportAnt AssEMBLy tIp: Do not tighten any nut and bolt combi-

nations completely until all parts are assembled together! Finger

tighten plus one turn of a wrench only! this will temporarily hold the

lock nut on the bolt while helping alignment of all parts! After all parts

are assembled together, all nut & bolt combinations must be com-

pletely tightened.

1. Attach one tree hugger (SS12) to each stick section using (1) provided

1/4-20 x 3" bolt, 1/4" washer and locknut on each section. SEE FIGURE 1.

Tighten all nut & bolt assemblies. Be sure not to over tighten or crush

tubing when tightening!

notE: head of bolt should be on front side of step and washers and locknut

should be on back side of tree hugger.

2. Attach the provided anti-slip tape (48104) to the top side of each step. The

step must be clean and at room temperature to assure proper adhesion.

3. Thread the snap hook of strap through the pocket on the vertical post of

each section. SEE FIGURE 2. Temporarily and loosely tie the strap (48748)

to the Rapid Stick section to prevent it from falling off during transport and

uprighting.

Figure 1

locknut

1/4-20 x 3" bolt

Figure 2

pocket on

vertical post

1/4" steel washer

snap hook

4. Sections are assembled on the ground in the following order: bottom

section (SS9), middle section (SS10), top section (SS11). SEE FINISHED

15' RAPID STICK. Sections are stacked together by sliding sections

together, inside of each other.

notE: on 20' model, a second middle section (ss10) is inserted between

bottom and top sections. sEE FInIshED 20' rApID stIck.

notE: If you purchased the optional 5' Extension (rE710), it is to be

inserted (positioned) between top & bottom sections. Extensions are

the same design as the middle sections that come with a complete 15'

rapid stick or 20' rapid stick.

SET-UP AND USE INSTRUCTIONS

1. Stand the stick up against the selected straight tree on dry, level ground.

Take the buckle end of the bottom section strap, wrap it around the tree,

and attach it to the snap hook end of the strap. Pull the strap so that the

section is snugly secured to the tree. SEE FIGURE 3. Be certain (2) two

contact points of tree hugger are contacting the tree.

notE: Be sure you wrap the strap correctly so there are no twists in the

strap and that the cam lever of the buckle is facing away from the tree.

2. While properly wearing/using a Full Body Harness, climb the climbing aid

only far enough to reach the middle section strap and attach it to the tree.

Repeat step 1 for proper attachment.

3. Repeat steps 1 and 2 for strap attachment for each section until all sections

are securely attached.

4. Reverse set-up and use instructions to take down climbing aid.

Figure 3

PRESS

PRESS

PULL TIGHT

TAIL