Autostart AS-1757v - Manual (Page 5)

User guide P. 5
¾ Passive mode:
• To arm the Starter Kill, press the
LOCK button on the transmitter, OR
• In Passive Mode, the Starter Kill will also automatically arm 1 minute (by default) or 3 minutes
(if configured this way) after the ignition is turned OFF or once the last door is closed (if the
doors are monitored).
- The LED on the antenna will flash quickly during the countdown preceding the
activation of the Starter Kill.
- Once the activation countdown expires, the LED will send a series of quick double
flashes to indicate that the Starter Kill is now armed.
• To disarm the Starter Kill, press the UNLOCK button on the transmitter.
- The Starter Kill will automatically rearm itself after 1 minute (by default) or 3 minutes
(if configured this way) if no door is left opened (if the doors are monitored) and the
ignition is not turned
ON .
¾ Active Mode:
• To arm the Starter Kill, press the
LOCK button on the transmitter.
- The parking lights will flash once.
- The LED on the antenna will flash slowly.
- If remote door locks are installed, this will also lock the doors and arm the OEM-style
alarm.
• To disarm the Starter Kill, press the
UNLOCK button on the transmitter.
- The parking lights will flash twice.
- The LED on the antenna will remain OUT .
- If remote door locks are installed, this will also unlock the doors.
Remote-Starting Your Vehicle
If your vehicle has an automatic transmission, simply press the START/STOP button to remote start
or stop your vehicle. Skip the next steps on to “Remote-starting”.
Warning: If your vehicle has an automatic transmission and the parking lights flash 15 times after
pressing the
START/STOP button, the parking brake is connected to ground. It is imperative that you
see your installer and have him disconnect the wire.
Setting Your Vehicle Into Ready Mode
If your vehicle has a manual transmission you must read the following indications. In order to
start the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on
the option that was selected by your installer. Therefore, you must follow the appropriate
procedure between the two described below in order to set your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door or the hood is opened, if the brake pedal is pressed, if
the parking brake is disengaged or if the ignition key is turned to the
IGNITION ON (RUN) position.