Autostart AS-1757v - Manual (Page 4)

P. 4 User Guide
x To access a feature that is programmed as level 2, press the PANIC/AUX button twice followed by
the desired function.
x To access a feature that is programmed as level 3, press the PANIC/AUX button three times
followed by the desired function.
Your installer can customize the system as to personalize these multi-level features in an order that
best suits you.
Your options are:
Option 1:
Level 1 (requires pressing the PANIC/AUX button 1X) Æ Multi car operation
Level 2 (requires pressing the PANIC/AUX button 2X) Æ Basic features
Level 3 (requires pressing the PANIC/AUX button 3X) Æ Customized features
Option 2:
Level 1 (requires pressing the PANIC/AUX button 1X) Æ Basic features
Level 2 (requires pressing the PANIC/AUX button 2X) Æ Multi car operation
Level 3 (requires pressing the PANIC/AUX button 3X) Æ Customized features
Option 3:
Level 1 (requires pressing the PANIC/AUX button 1X) Æ Customized features
Level 2 (requires pressing the PANIC/AUX button 2X) Æ Multi car operation
Level 3 (requires pressing the PANIC/AUX button 3X) Æ Basic features
Option 4:
Level 1 (requires pressing the PANIC/AUX button 1X) Æ Basic features
Level 2 (requires pressing the PANIC/AUX button 2X) Æ Customized features
Level 3 ( requires pressing the PANIC/AUX button 3X) Æ Multi car operation
Example: If the multi-level features were set to option 3, the setup would be as follows:
x Level 1 Æ Customized feature
x Level 2 Æ Multi car operation
x Level 3 Æ Basic features
The “Basic features” are now programmed as level 3 and therefore:
x
To access cold weather mode, the user needs to press on the PANIC/AUX button three (3) times
followed by the START/STOP button.
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
HIGH . It is recommended to leave the settings on LOW or MEDIUM
instead.
Windshield Wipers, Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are
OFF . Leaving the headlight switch ON on certain types
of vehicles could cause them to remain ON even after remote starter shut down, resulting in a dead
battery.
Arming the Starter Kill
The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm
automatically) or Active Mode (so as to require the user’s intervention for arming). By default, your
Remote Car Starter is configured to Passive Mode.