LOCKSTATE LS-60 Operation Guide - Manual (Page 15)

PG
14
PG
14
PG
15
MODE Button
The mode button sets the LS-60 to HEAT COOL or OFF modes. Press it once to step to the next
mode. If the LS-60 is in OFF and you want to return to the mode you were previously in, touch the
OFF indicator on screen.
FAN Button
The fan control is normally in AUTO mode, meaning that the fan operates automatically with the
HVAC system and the thermostat. When the fan button is pressed the fan goes ON; the fan will run
continuously in this manual override until switched back to AUTO by pressing the FAN button again.
[NOTE: Fan ON function is available in the OFF mode to allow simple ventilating.]
Simple Screen
This display mode limits the amount of information on screen and limits the functions to just the +/-
arrows and the MENU button.
Hold down the PROGRAM button for 12 seconds to access the limited display screen.
Hold down the PROGRAM button for 12 seconds to leave the limited display screen.
RESET button The RESET button re-boots the LS-60 processor. It does not effect the user
programs that have been stored in permanent memory.