LOCKSTATE LS-60 Installation Guide - Manual (Page 7)

PG
7
Mount the LS-60 to Wall
1. Hold the LS-60 against the wall, with the wires coming over the top;
above terminal block. The LS-60 will cover the hole in the wall.
2. Position LS-60 for best appearance.
3. Attach the LS-60 to the wall with the screws provided.
4. If you are mounting the LS-60 to sheet rock or if you are using the
old mounting holes, use the plastic anchors provided.
5. Mark first and drill a 3/16-in.(4.8mm) hole for the insert at each
screw location, then mount the unit.
Screw to wall
Place wires like this
C B O W W2 Y Y2 RHRCG A
from
HEA
T/COOL
system
C B O W W2 Y Y2 RHRCG A
C
W
Y
RH G
Wall
Wires
Wall
anchor
LS-60