Step-by-step wiring diagrams – LOCKSTATE LS-60 Installation Guide User Manual
Page 13

PG
12
PG
12
PG
13
Step-by-step wiring diagrams
WIRES
2 Wire Heat GAS MILLIVOLT or 24VAC system
STEP 1 - Connect the R (or RH) wire to the RH terminal. This connects the heat power.
STEP 2 - Connect the W wire to the W terminal. This connects the heat.
STEP 3 - Set HVAC selection switches to NORMAL and GAS.
Your heater is now connected to the LS-60.
Please Go To Page 6
WIRES
3 Wire Heat
STEP 1 - Connect the R (or RH) wire to the RH terminal. This connects the heat power .
STEP 2 - Connect the W wire to the W terminal. This connects the heat.
STEP 3 - Connect the G wire to the G terminal on the thermostat. This connects the fan.
STEP 4 - Set HVAC selection switches to NORMAL and:
If you have gas or oil heat, set the HEAT TYPE to GAS.
If you have electric heat, set the HEAT TYPE to ELEC.
Your system is now connected to the LS-60.
Please Go To Page 6
W
R
C
C H B O W
2
W
Y Y
2
RH RC G A
RADIO POWER
W R
G
C
HVAC SYSTEM
REMOTE POWER
C H B O W
2
W
Y Y
2
RH RC G A
AC SYSTEM
HV