King Kooker 2292 V Bottom Outdoor Cooker - Manual (Page 12)

12
3. Locate the cooker body and four legs. Install the four legs into the cooker body by matching the
letters on the legs to the letters on the leg receivers (for example: A to A, B to B, etc...). Snap in
leg bolts through receiving holes on frame. Make sure the leg bolts pop completely out and legs
are locked in position.
4. Make sure that the adjustable heat plate located on the front of the cooker body is raised to the
uppermost position in preparation of the installation of the burner. Locate the end of the burner
with the venturi. Insert the venturi end of the burner through the hole located on the front of the
cooker body (insert from inside cooker body to outside.) The end of the burner with the venturi
should stick out of the front of the cooker body. Attach the burner to the inside of the cooker body
by inserting the two supplied bolts through the supplied holes in the burner and cooker body
as pictured in Figure 1 below. Tighten with supplied lockwashers and nuts. Once the burner is
installed, the adjustable heat plate located on the front of the cooker frame must be lowered into
position before use. Loosen the bolt and lower the heat plate to close the hole above the venturi.
Tighten bolt when finished. See below Figure 2.
5. Place the V-Bottom Pot onto the cooker body as pictured below in Figure 3.
6. Check that the venturi tube is free of obstruction. Tighten the hose fitting into the venturi with a
torque wrench, up to a torque of 95 to 105 lb.in. Alternatively, hand tighten securely and then,
using a wrench, tighten an additional 1-1 1/2 turns. See below Figure 3.
20 lb. LP
Gas Cylinder
toP VIeW
COOKING POT
VENTURI TUBE/
AIR SHUTTER ADJUSTABLE REGULATOR
TYPE 1
CONNECTION
1/8 MALE PIPE
THREAD WITH
ORIFICE
TIMER
Figure 1
Figure 3
Venturi
Figure 2
Heat
Plate
Bolt
Venturi/
Air Shutter
Spigot
Hole
Burner
Bolt
Attachment
Bolt
Attachment
SPIGOT