How to set the temperature override, Temperature override – APC NetworkAIR Rack Air Removal Unit ACF102BLK User Manual

Page 17

Text mode
Original mode

Operation

NetworkAIR Rack Air Removal Unit Installation

How to set the temperature override

The temperature override switch is recessed inside the space marked A-Link Address. Use a small
tool such as a pocket screwdriver to set the DIP switch to the correct position. Set the DIP switch
labeled 1 to the desired position according to the table below.

Symbol

Temp Override

Enabled

Disabled

Warning

When in kW mode and using a UPS that is 3000VA or lower, disable the
temperature override to prevent the power draw from exceeding the limitations of
the UPS.

Note

When using the APC Environmental Management System, you can change the
temperature override setpoint.

1 2 3 4

Temperature

Override