Thz-d series, Smart interface” connector, 2 thz-d series “smart interface” connector – Gentec-EO THZ-D User Manual
Page 7
7
Revision 1.1
THZ-D Series Instruction Manual
Gentec Electro-Optics Inc. All rights reserved
2.2 THZ-D Series
“SMART INTERFACE” CONNECTOR
The DB-
15 male “Smart Interface” connector contains an EEPROM (Erasable Electrical Programmable
Read-Only Memory) programmed with the calibration sensitivity and other data related to the specific
THZ-D
wattmeter in use. Faster set-ups are obtained because the monitor automatically adjusts to the
characteristics of the watt
meter, when the “Smart Interface” is connected to the monitor.
The DB-
15 “Smart Interface” connector pin-out is (see Fig. 1-1):
1-
USED BY MONITORS
2-
"
"
"
"
3-
"
"
"
"
4-
"
"
"
"
5-
"
"
"
"
6-
“+” SIGNAL OUTPUT
7-
‘’-’’ SUPPLY VOLTAGE THZ9D ONLY
8-
USED BY MONITORS
9-
‘’+’’ SUPPLY VOLTAGE THZ9D ONLY
10-
USED BY MONITORS
11-
"
"
"
"
12-
"
"
"
"
13-
“-“ SIGNAL OUTPUT
14-
USED BY MONITORS
15-
"
"
"
"
SHELL-
COAX. SHIELD / BODY GRND
NOTE : Verify with Gentec-EO for supply voltage requirements.