Gentec-EO MACH 6 - Manual (Page 6)

Mach 6 User’s Manual Revision 2.1 6
Figure 2, Mach 6 Back Panel
Installing the Software
Do not plug the Mach 6 into your PC yet.
Step 1, Installing the Applications Software.
1. Insert the installation CD. The installation will start automatically. If it does not,
browse to the setup.exe file on the CD and run it.
2. The Welcome to the GENTEC-EO Mach 6 Installation Wizard will open. Select
Next.
3. The Select Destination Folder dialog box will open. It is recommended that you
leave the destination folder at the default setting. Select Next.
4. The Ready to Install the Application dialog box will open. Select Next. The
application software and support files will be installed.
5. Upon completion of the installation, the Success dialog box will open. Select
Finish.