Gentec-EO MACH 6 User Manual
Page 22
Mach 6 User’s Manual Revision 2.1
22
The selected stats will be stored, comma separated. The last value stored will always be
the Error Flags for the data set.
An error flag is decoded as follows:
0 = no errors in batch.
1 = out of range error for one or more pulses in batch.
2 = over temp error for one or more pulses in batch.
3 = out of range and over temp errors for one or more pulses in batch.
Write to Single File
If this box is checked then data will be written to a single file rather than an auto
incremented series of files. This is useful when small results files are expected, as is the
case with small batches or storing statistics only. Each set of test data will be appended to
the file, and the Additional file information will be placed at the end of the complete file.
Addition File Information
Every data file will also contain the date, time, Additional File Information, and the
state of the Mach 6 when the data was taken.
The Indicators are:
Test Number
The currently running test or the last ran test.
Number of Tests
The number of tests that will be ran. This number is:
Test Duration / Test Interval rounded to the next highest integer.
Test Duration
The elapsed time from Start Time to Stop Time, in hours.
Test Status