AT&T 1450 - Manual (Page 16)

13
4 When you finish entering the name, press
S or G.
The screen displays ENTER NUMBER.
5 Enter the telephone number. Use
< to backspace and make
a correction. Press
P to store a pause in the dialing sequence.
—OR—
Press
P to display the last number dialed from
this phone.
6 Press
S or G. The screen displays DISTINCT RING?
and the current setting.
7 Press
< or > to change the setting. Choose Y (for Yes) if you
wish the phone to alert you to calls from this number by changing
to a distinctive ringing pattern after the first ring. Choose N (for
NO) for a normal ringing pattern.
8 Press
S or G to confirm your selection. If you chose
Y in Step 7, a D will be displayed with the directory entry.
Note: When memory is full the screen displays MEMORY FULL, an error
tone sounds, and you will not be able to store a new number until you
delete a stored number.
Edit a Number/Name Stored in the Directory
1 Press
> (DIR). The screen displays DIRECTORY.
2 Press
< or > to scroll alphabetically through entries
stored in memory
—OR—
Press the dial pad key for the first letter of the entry you
want to edit.
3 When the screen displays the number you want to edit, press
S. Then press < or > until EDIT flashes.
4 Press
S. The screen displays the name and number. The
flashing cursor appears at the end of the name. Use
<, > and
the dial pad keys to edit the name. Press
S to move on to
edit the number. Press
S to move to edit the Distinctive
Ring setting.
5 Press
S to save the edited information.
E ED DI IT T DIAL ERASE
973-555-0123
TELEPHONE DIRECTORY
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 13