Farm Star PBX-42 - Manual (Page 4)

6 3
S A F E T Y I N F O R M ATION (continued)
When maneuvering close to buildings or passing through narrow areas, be sure to allow sufficient clearance
for the implement and tractor.
Do not operate close to ditches or creeks. Slow down when operating over rough ground.
Always be sure the implement is in the fully raised position when in transport.
Pull from drawbar only. Failure to hitch properly could cause tractor to flip over, resulting in serious injury or
death.
Reduce speed on slopes and sharp turns to minimize tipping or loss of control. Be careful when changing
directions on slopes. Do not start or stop suddenly on slopes. Avoid operation on steep slopes.
Never exceed the limits of a piece of machinery. If its ability to do a job, or to do so safely, is in question -
DON’T TRY IT.
Avoid excessive speed during operation.
Make adjustments only when the implement is attached to the tractor.
Always ease the tractor into the load. It may be necessary to reposition and take less “bite” on the material to
move it safely.
Watch for and avoid hidden obstructions, i.e., buried pipes, rocks, concrete piers, uneven concrete slabs,
stumps, etc., when operating landscape rakes, box scrapers, or other ground engaging implements.
Never operate tractor and implement under trees with low hanging limbs. Operators can be knocked off the
tractor and then run over by the implement.
Stay alert for holes, rocks and roots in the terrain and other hidden hazards. Keep away from drop-offs.
Use extreme care and maintain minimum ground speed when transporting on hillside, over rough ground and
when operating close to ditches or fences. Be careful when turning sharp corners.
Pass diagonally through sharp dips and avoid sharp drops to prevent “hanging up” tractor and implement.
Practice will improve your skills in maneuvering rough terrain.
Always angle down slopes; never across the face. Avoid operation on steep slopes. Slow down on sharp turns
and slopes to prevent tipping and/or loss of control.
Always shut off tractor and shift to “Park” or set brakes when leaving tractor. Always lower implement to
ground. Remove key when leaving tractor unattended.
Before operating equipment: if you have any questions regarding the proper assembly or operation, contact
your dealer or representative.
I N S T R U C T I O N S (continued)
Straighten or replace any tines which may have bent
due to hitting buried or solid objects.
Check the angle shift pin for excessive wear and
replace if necessary.
Repaint parts where paint is worn or scratched to
prevent rust.
Check all bolts and nuts to be sure they are tight except
nylock nut pivot bolts – these should be just snug.
Periodically oil the following:
Turnbuckle threads
Pivot points
M A I N T E N A N C E
At the end of the working season or when the implement
will not be used for a long period, it is good practice to
clean off any dirt that may have accumulated.
Inspect the implement for loose, damaged or worn parts
and adjust or replace if needed.
Repaint parts where paint is worn or scratched to
prevent rust.
Store in a clean, dry place away from where children
play.
S T O R I N G S A F E LY
O B E Y A L L
S A F E T Y WARNINGS!!
U Keep children away from danger all day, every day.
U Equip tractors with rollover protection (ROPS) and keep all
machinery guards in place.
U Please work, drive, play, and live each day with care and
concern for your safety and that of your family and fellow
citizens.