Farm Star BBSF-12 - Manual (Page 10)

9 6
Avoid excessive speed during operation.
ALWAYS lower spear points to the ground when parking tractor. Raised spear points could cause injury to
people or livestock.
Always shut off tractor and shift to “Park” or set brakes when leaving tractor. Always lower bucket or attach-
ment to ground. Remove key when leaving tractor unattended.
Before operating equipment: if you have any questions regarding the proper assembly or operation, contact
your dealer or representative.
S A F E T Y I N S T R U C T I O N S (continued)
OPERATIONAL SAFETY (continued)
When using a unit, a minimum 20% of tractor and equipment weight must be on tractor front wheels. Without
this weight, tractor could tip over, causing personal injury or death. The weight may be attained with a front
end loader, front wheel weights, ballast in tires of front tractor weights. When attaining a minimum 20% of
tractor and equipment weight on the front wheels, you must not exceed the ROPS weight certification. Weigh
the tractor and equipment. Do not guess or estimate!
Comply with state and local laws governing highway safety and movement of farm machinery on public roads.
The use of flashing amber lights is acceptable in most localities. However, some localities prohibit their use.
Local laws should be checked for all highway lighting and marking requirements.
When driving the tractor and equipment on the road or highway under 20 mph (32 kph) at night or during the
day, use flashing amber warning lights and a slow moving vehicle (SMV) identification emblem.
Always be sure the implement is in the proper raised position for transport.
Reduce speed when transporting mounted implements to avoid bouncing and momentary loss of steering
control.
TRANSPORT SAFETY
Transporting large round bales on front loaders can limit visibility. Keep load low and go slow if visibility is
obstructed. Always use extra care.
Make sure large round bales transported on tractor rear 3 pt. hitch do not obstruct visibility of tractor’s flash-
ing lights or SMV sign.
When transporting large round bales, keep load as low as practical to maximize tractor stability.
Turn curves or go up or down hills only at a low speed and at a gradual steering angle. Make certain that at
least 20% of the tractor’s weight is on the front wheels to maintain safe steerage. Slow down on rough or
uneven surfaces, and loose gravel.
Use extreme care and maintain minimum ground speed when transporting on hillside, over rough ground and
when operating close to ditches or fences. Be careful when turning sharp corners.
Never allow riders on either tractor or implement. Falling off can kill.
• Read and follow owner’s
manual before installing,
operating, or performing
maintenance on this loader.
Observe safety recommen-
dations in manual.
• Loader must have a lift
capacity 1000 lb. greater
than the weight of bale to
be handled.
• Do not lift or carry anyone
on loader or in bucket or
attachment.
• For operator safety, always
keep bale in front of tractor
hood. NEVER position bale
back over operator.
• Add recommended wheel
ballast or rear weight for
stability. When handling
loads on both ends of
tractor, load rear first and
unload last.
• Set wheels wide for
increased stability.
• Never raise loader to extreme
heights on steep inclines.
• Do not stand or work under
raised loader.
• Stop engine, lower arms,
relieve all hydraulic pres-
sure, and lock brakes before
leaving operator’s seat.
• When handling round bales
with fork type equipment,
be sure bolt-in stabilizer
spike is installed. Without
spike, uncontrolled bale
movement could occur.
• Failure to observe the above
precautions could result in
serious injury or death.
101026
CAUTION
S A F E T Y S I G N S
NOTICE
1500 LB.
CAPACITY
101040
NOTICE
1800 LB.
CAPACITY
101112
Replace
Safety Decals
if damaged
or missing.
MOUNTING INSTRUCTIONS
BBS-10 & BBSF-12 (Bolt-On)