Fairbanks Aegis Xtreme-Duty Floor Scale - Manual (Page 21)

Section 3: Scale Installation
11/08 21 51206 Rev. 1
C A U T I O N
3.3. INSTALLING ACCESSORIES/MODIFICATIONS
Listed below are the standard Aegis Xtreme-Duty Scale Accessories.
• Aegis Xtreme-Duty Ramp • Stand-alone Instrument Pillar
• Intrinsically Safe Controllers • Smart Sectional Controllers
• Flush-Grade Pit Frame • Intalogix Technology (QMB)
3.3.1. Ramp Installation
The ramps are optional, and used different
ways in varied applications.
• Each ramp has two (2) bolt down tabs, one
on each side.
1. Place the ramp against the platform frame
─ The ramp’s slot is fits inside the scale’s
lifting point.
─ Level and stabilize the ramp against the platform.
─ Shims are not included with the ramps and must be
supplied.
2. Drill and anchor the ramp(s) using the supplied 3/4” wedge
anchors.
─ Up to four (4) ramps can be installed on the Aegis
Xtreme-duty Scale , one on each side.
Absolutely NO ARC WELDING is to be performed on, or near
this scale while the Load Cells are in place and/or connected.
Disconnected and removed ALL the Load Cells during ANY
welding.