Fairbanks Series II Bench Scales - Manual (Page 6)

07/10 6 50777 - Rev. 6
A. General Service Policy
It is the customer / operator's responsibility to ensure the equipment provided by Fairbanks
is operated within the parameters of the equipment's specifications and protected from
accidental or malicious damage. Other than the procedures authorized in this manual, no
service, repair, or adjustments may be performed by unauthorized / untrained service
personnel. Any unauthorized repairs will void any verbal, implied, or written warranties.
B. Overview
1. These instructions apply to the instrument and its specific installation procedures.
2. All electronic and mechanical calibrations and/or adjustments required to make this
equipment perform to accuracy and operational specifications are considered to be part of
the installation, and are included in the installation charge. Only those charges which are
incurred as a result of the equipment's inability to be adjusted or calibrated to performance
specifications may be considered warranty.
3. Absolutely no physical, electrical or program modifications are to be made to this equipment.
Electrical connections other than those specified may not be performed, and physical
alterations (holes, etc.) are not allowed.
4. Before the installation is considered complete, the equipment is to be programmed to meet
or exceed any applicable weights and measures requirements, if applicable. The installing
technician is responsible to make certain customer’s personnel are fully trained and familiar
with the capabilities and limitations of the equipment. Be prepared to recommend the
arrangement of components which will provide the most efficient layout, utilizing the
equipment to the best possible advantage. The warranty policy must be explained and
reviewed with the customer.
C. Unpacking
1. Check that all components are on hand, and agree with the equipment order.
2. Remove all components from their packing material, checking to make certain that all parts
are accounted for and no parts are damaged. Advise the shipper immediately if damage
has occurred. Order any parts necessary to replace those which have been damaged.
Keep the shipping container and packing material for warranty returns, if necessary.
Check the packing list.
3. The shipping carton should contain the following: Manual, Instrument, Platform,
Pillar, and AC Adapter.
Section 2: Installation