Fairbanks Series II Bench Scales - Manual (Page 12)

07/10 12 50777 - Rev. 6
B. Operation
1. Taring
All models have taring capabilities up to their total weight capacity. To weigh a sample in
its container with the display showing the weight of the sample use the following tare
procedure.
a. Place sample container on pan and then press the
b. Now place sample in its container.
c. When the balance is stable, the display shows the weight of the sample.
2. Counting Function
a. Counting feature must be enabled; it comes from the factory disabled.
b. Count the desired number of sample pieces (10, 20, 50, 100 or 200 total pieces )
c. Press
This number will cycle.
Press
Once it is displayed, the arrow at the bottom of the display will point to PCS.
d. You are now ready to perform parts counting of those specific pieces.
Repeat steps b through d for each type of piece to be counted.
3. Weighing Units Selection
key.
key to display total count numbers of 10, 20, 50 or 100, or 200.
key again to select sample size.
key for the total weight. Press
Press and hold key then press key for lb or kg selection.