Fairbanks 6001 Delta Series Analog Platforms - Manual (Page 6)

50661 6 12/04 Issue #4
TOOLS
REQUIRED:
• #1 Phillips
screwdriver
• 7/64” Allen
wrench
Section 4: Parts Replacement
A. Load Cell Replacement:
1. Remove power to the indicator.
2. Set the platform up-side-down, unscrew and remove all four feet.
3. Use a 7/64” allen wrench to remove the screws in the foot holes.
4. Place the platform upright without the cover.
5. Unplug the suspect load cell from the load cell junction assy.
6. Remove the screws holding the load cell and spacer in place.
7. Remove the load cell and cable.
NOTE the cell and cable placement!
8. Install the new load cell and the spacer(s).
9. Tighten the load cell mounting screws to 8 ( ± 2 ) INCH/LBS of
torque ONLY.
10. Route the load cell cable exactly as the original's cable & plug
connector in.
11. Place the base up-side-down into the platform cover and align
the holes.
12. Insert the allen head screws and tighten to 8 (± 2 ) INCH/LBS of
torque ONLY.
13. Calibrate the indicator.