Direct Lift PP8S - Manual (Page 25)

25
h. If entire 2” clearance cannot be attained by adjusting the locking latch bar, adjust the cable. Turn cable
adjusting nut to raise the locking latch 2” above bottom of latch bar slot. Tighten cable jam nut.
i. Lower lift and remove vehicle.
j. Raise the lift to full height. LISTEN and WATCH as the first locking latch clicks into place. Synchronize
the other three columns with this column by adjusting their cables so all four latches click at same time.
Tighten jam nuts.
When making changes to adjustment nuts on cable end or latch bar stud, always leave at least two threads
showing between nut and stud end.
Latches may not click in at the same time when vehicle is being raised. They should be close. Be sure all four
corners have passed the locking latch bar slot before lowering lift on locking latches.